The all-new AMMO FRAME PRO TRIM COAT is a long-lasting semi-permanent trim coat for restoring and improving upon the factory finish of textured black trim, plastic cladding, and bumpers found on most cars today. Packaged in a convenient dispensable wipe, the coating is easy to apply by hand and cures quickly within an hour in normal conditions. Frame Trim Coat will leave behind a rich deep black finish on trim surfaces improving contrast to better "frame" your vehicles design. 1 pack (3 wipes) is sufficient to completely cover the trim surfaces of the average vehicle. Using a specially designed ceramic formula, Frame will have long-lasting durability with a desirable rich finish. Please wear all recommended protective gear and all surfaces should be cool prior to application. Follow cure time instructions prior to operation of the vehicle. **NOTE: Frame Pro will not adhere correctly if trim is unclean or previously been coated. Trim must be completely bare and stripped of any prior coating for best results. Recommended on exterior textured trim surfaces.**
1. Wash area with dish soap or BRUTE thoroughly. If necessary, scrub with TITAN 12 degreaser and small stiff brush prior to thorough wash if trim is wax-stained.
2. Dry with compressed air.
3. Put on protective gear: latex gloves, safety glasses, and mask. Work in well-ventilated area.
4. Open packet, remove applicator, apply to dry trim with over-lapping motions in even strokes for smooth, "level" layers.
5. Do not get wet or drive for 1 hour to fully cure.
NOTES: Trim must be 100% dry for coating adhesion. Cloth applicator will be strongest during first applications and slowly deplete as product is applied. Be mindful of how much product is "layered" at first. Flip and refold applicator for more product to be released as it becomes dirty.
A: Due to the adhesion to trim surfaces and the flexible nature of the plastic, the formula is a specialized trim ceramic that has a very strong odor. PPE is recommended.Q: What protective gear should I wear when applying Frame?
A: Latex Gloves, Safety Glasses, and Mask. Work in well ventilated area.Q: Is Frame a ceramic coating?
A: Yes, it's a semi permanent ceramic coating formulated for trim with 1-2 years protection. (weather dependent)Q: How long should I let Frame cure?
A: Allow frame to cure for 1 hour in dry conditions. Do not drive or get wet prior to Frame curing.Q: What surfaces are safe to apply Frame?
A:Black trim, plastic cladding, rubber moldings, adheres best to clean textured surfaces.Q: Is Frame safe to use on plastic trim in engine bays and bumpers by exhausts?
A: Yes, Frame Pro can be applied on appropriate plastic covers and bumpers in these areas if the surface is cool and clean. Vehicle should not be running and Frame should cure for the full 60 minute duration before vehicle operation. Do not apply Frame to engine components or exhaust pipes.
I have been using Ammo products for a little over two years now. Frame pro was or is amazing. I have used other brands similar to this, but frame on my wife's q7...awesome. thought about only doing half the car to demonstrate the difference, but it looked too good to stop.
The trim coat was easy to put on and looks absolutely amazing after application! I have been a follower of AMMO for at least 6-7 years. Thanks for all you do in the detail community!
I cleaned the trim as described on the packaging and wiped on the product on some tired looking plastic trim on my 2015 Lexus RX and good lord, they look brand new! Its not exactly shiny more so just "new" but man is it gorgeous. Highly recommend.