1. Wear latex gloves, eye protection, mask, and work in a well-ventilated area.
2. Prior to first coat application, wash and clay the paint if needed.
3. If needed, use isopropyl alcohol mixed 50-50 with water or an automotive grade wax and silicone remover to decontaminate surface.
4. Prime microfiber applicator and apply in overlapping motions in 2x2 sections.
5. Allow 2-3 minutes dwell time until cured (wait for the rainbow to appear).
6. Lightly remove excess with a microfiber towel.
NOTE: Best if applied on cool surfaces, out of direct wind, and no water/rain for 6 hours after application. Dependent on conditions and thickness of application, may take a week to fully set.
These product are recommended to be used with Reflex Pro
A: Yes. Coatings vary drastically, but this has a very high percentage (once cured) of SiO2 with carbon residues. This product contains polsilazines, solvents, and additives which are thermo-setting resins at room temperture. (ie do not require a UV light)Q: How do I maintain Reflex Pro?
A: Maintenance is exactly the same as a none coated car, however, abrasives will remove the coating. In other words, perform a healthy wash (when needed) with AMMO Foam or favorite car soap, dry with Hydrate, and use Reflex Pro Top Coat as often as you feel is required. The more layers of protetection (Skin, Reflex Pro Top Coat, Creme, etc...) the more protected the "base layer" of Reflex Pro will be.Q: How long does Reflex Pro take to cure?
A: Depends on humidity and ambient temps, but 30 secs to 2 minutes is the average flash time before buffing off. One layer is advised for application and minimum curing time of 6 hours in a dry environment. Reflex Pro may take up to a week to fully set and will perform optimally after 1st wash.Q: How do I prep the paint before applying Reflex Pro?
A: Wash the paint, remove the contaminants with clay (if necessary), compound and polishing (if necessary) is always the best option as the Reflex will have extra depth and shine over "leveled" paint. Light ISO wipes (spray on towel first) can be helpful if paint was recently waxed. You can layer Reflex Pro over "old" layers of Reflex Pro without removing the old layer.Q: Can I use other paint care products (wax, sealant, spray wax) after Reflex Pro is applied?
A: Yes. However, the top layer (most upper surface) will give the paint its water characteristics. Hydrophobic or Hydrophilic. I prefer to layer AMMO SKIN over it every few months as its "jacket" or sacrificial layer. I also use Reflex Pro Top Coat after every wash.Q: Is Reflex Pro safe on matte paint or vinyl wraps?
A: Yes. It will bring more depth or "richness" to the color but it will not be "shiny" afterwards. I highly recommend it on matte paint or vinyl as it is really the only type of protection for those areas without causing a deep shine (therefore defeating the matte finish).
I take care of my vehicles and hate to spend money on products that do not work. This product is FANTASTIC. Which reminds me. I need to order more!
Reflex Pro goes on and wipe off very easely. 100% recommand this coating